DynaVap M Plus

The M Plus is machined from medical-grade stainless steel throughout. No plastic parts, no rubber seals, no battery cells that fade after two years. Drop it on concrete and pick it back up – it will be fine. After years of daily use, it barely looks different from day one.

The body features a series of small indentations along the stem that improve grip and add a bit of visual texture. At 21 g it is one of the lightest vaporizers on the market. There is genuinely nothing fragile about it.

The M Plus uses hybrid heating. The chamber walls transfer heat directly into the herb (conduction), while hot air passes through the material at the same time (convection). The result is rich, flavorful vapor from a very small load.

On-demand operation means every session starts fresh. No preheating for several minutes, no standby mode burning through material. Heat, draw, cool, repeat. A typical chamber holds enough for one to three draws depending on how tightly you pack. For a flameless alternative, induction heaters like the YLL 3.0 or the Ispire Wand work well.

Near the bottom of the M Plus stem is the airport – a small hole you can cover with your thumb, fully or partially. Open airport gives a light, airy draw. Covering it concentrates the vapor noticeably. Most users settle on a middle ground after a few sessions.

The M Plus connects directly to water pipes via its 10mm fitting, which fits most standard bongs. Dosing capsules (sold separately) allow quick strain changes and keep the chamber much cleaner between sessions.

A torch lighter is the standard heat source – unless you use an induction heater. Devices like the Ispire Wand or the DynaVap Induction Heater warm the Captive Cap via a magnetic field in around 3–5 seconds. No open flame, no butane, no fire near the device at all.

The click mechanism works exactly the same. Induction heaters cost extra but make a real difference for indoor sessions or anyone who prefers not to deal with a torch. The M Plus stays the same device – only the heat source changes.

DynaVap has one of the most active vaporizer communities anywhere. On Reddit, YouTube, and various forums, users share heating tips, custom builds, and accessory recommendations in detail. Once you are in the DynaVap ecosystem, it tends to stick.

Cleaning is quick: remove the cap, wipe the stem with an isopropyl alcohol swab, soak the cap in iso if needed. No electronics means no fear of liquid damage. The whole process takes about two minutes.

• DynaVap Official Website

The VonG pairs a titanium tip with a hardwood body. Titanium heats up faster than stainless steel and cools down quicker too – ideal for rapid reloads.

The VonG has an integrated 14 mm glass joint. Just plug it into a bong — no WPA adapter needed. The combination of DynaVap extraction and water cooling delivers dense, cool draws.

Unlike most DynaVap models with stainless steel tips, the VonG uses titanium. Titanium heats up faster (about 5 seconds vs. 7) and cools down quicker too. Ideal for quick reloads.

The VonG body is made from selected hardwood. This provides better heat insulation than stainless steel — the grip stays cooler. Each unit has a unique grain pattern.

Soak tip and cap in isopropanol, but only dry-wipe the wooden body or treat it with a little oil. Wood and alcohol don't mix. Clean the glass joint regularly with a cotton swab for a proper seal.

• DynaVap Official