Pros
- Just 3 seconds heat-up time, immediately ready to vape
- Swappable 18650 battery, unlimited backups possible
- Pure convection, clean vapor without material contact
- 3-year warranty, Finnish quality craftsmanship
Cons
- No dosing capsules, material must be loaded by hand
- No app control, manual operation only
- Passthrough charging puts more stress on battery over time
How to Use - Getting Started for the Tinymight 2. You can find the complete overview on the main page.
How to Use - Getting Started
The Tinymight 2 has exactly one button. Everything is controlled through click sequences and vibration patterns - two reviewers compare the first few days to using Morse code, after which it becomes second nature. The combinations according to the manual:
| Action | Input | Feedback |
|---|---|---|
| Switch on On-Demand | Click quickly 3× | LED flashes; after activation, 1-4 vibrations indicate the battery level |
| Switch on Session | Click 3× and hold on the third click until the vibration ends | LED remains illuminated |
| Heat (On-Demand) | Hold the button, draw after the vibration, release | Heater stops immediately upon release |
| Boost (Session) | Hold the button during the Session | Temperature rises temporarily |
| Switch off | Click 3× | - |
| Stealth mode (lights off) | Session on, dial to maximum, click 1×, dial to minimum, click 1× | Reset by opening and closing the battery cap |
| Travel lock | Dial to 0 | Device cannot be switched on |
Battery indicator: green and four vibrations = full, blue and three = good, purple and two = charge soon, red and one = empty. Newer devices also show the colour on the rear and through the multitool holes at the front. One tip from the manual that is regularly absent from forums: if the vibration suddenly stops, silent mode has been activated accidentally - opening and closing the battery cap resets it.
The multitool attaches magnetically to the top of the device: for stirring, emptying and, when reversed, lightly tamping - and it has a recess that allows the temperature dial to be turned without using a fingernail.
Direct comparisons
More Tinymight 2 topics
Tinymight 2 Guides & Niches
A pure convection vaporizer. The manufacturer describes a stainless-steel coil heater that heats the air – there is no heated chamber wall and no conduction component. You therefore have to draw for longer than with hybrid devices such as the Mighty+, but in return the flavour remains consistent until the final draw.
According to the manufacturer, from three seconds. Reviews measure 3–5 seconds at level 4–6, around 10 seconds at level 8 or in Beast Mode, and 8–10 seconds with an almost empty cell. In Session mode, subsequent draws are possible after around 2 seconds.
According to the manual, levels 1 to 10 correspond to values from 140 to 250 °C, with Session mode limited to 230 °C. The manufacturer's FAQ quotes 120–240 °C – an older text. The entire range can be shifted up or down by as many as three levels through calibration.
On-Demand only heats while the button is pressed – ideal for individual draws without waiting or continued cooking. Session maintains the temperature until switched off and allows a button-operated Boost; the Classic model has no shut-off timer, while the black editions do. Session conserves the battery slightly, while On-Demand preserves flavour.
Only high-drain 18650 cells with at least 20 A continuous discharge: the manufacturer recommends Molicel P26A, P28A and P30B; forums also use Sony VTC6, LG HG2 and Samsung 30Q. Cells with 3,500 mAh and 10 A, as well as protected cells, are unsuitable. The positive terminal faces the cap.
Around five – measured in Session mode at level 6–7; around four in On-Demand operation. The range across reviews is three to eight, depending on the level, draw length and cell. A spare battery with a charging cradle is therefore essential for frequent users.
No. The manufacturer does not mention pass-through charging anywhere, Vapefully lists “Use While Charging: no" in the specifications, and German retailers say the same. The battery charges through USB-C with at least 2 A to 90 per cent in around 1.5 hours, or in around 40 minutes with a fast charger.
Three years from delivery – but only if the device is registered with the manufacturer within one year; it is not transferable. The battery, cable, glass tubes, screens and capsules are excluded. Devices purchased before 19 January 2024 still had a ten-year warranty.
Yes, at level 9 or above, with very dry material and an excessively hard draw. One reviewer recorded one combustion event per seven bowlfuls during the first week, but none from the fourth week onwards. Level 5–7 and steady, long draws prevent this; Beast Mode (level 10) is intended for concentrates.
No. Temperature is set using an analogue dial with levels 0–10, while the battery level is indicated by LED colour and vibrations. Anyone requiring degree-accurate reproducibility is better served by the Arizer Solo 3 or the Venty with its app.
Yes, with an adapter (14/18 mm or the manufacturer's 3-in-1 adapter). Water makes the scratchy vapour at high levels considerably more comfortable; a bowlful is often empty after two draws this way. The air path is narrower than the Venty's, which produces larger clouds through a bong.
Level 10 in On-Demand mode: the LEDs illuminate white and the device heats considerably more strongly than at level 9 – according to the manufacturer, it is intended for concentrates and is also used for hash in forums. Reviewers advise against using it for flower because the risk of combustion increases.
The manufacturer recommends weekly cleaning for frequent users and every two weeks for occasional users. The bottleneck is the cooling unit: reviewers clean it in isopropyl alcohol every five to twenty bowlfuls. The chamber remains largely clean thanks to convection; never place O-rings in alcohol or get the wood wet.
The black editions (Black, Black Walnut, Black Redwood) have a one-piece stainless-steel cooling unit v2 without O-rings, a zirconia tube instead of glass, a double screen, a stainless-steel funnel in the cap, Boost in On-Demand mode as well, a Session shut-off timer and the Molicel P30B. They cost EUR 399–449 instead of EUR 349.
According to almost every review, no: it requires long draws, stirring, knowledge of batteries and regular cleaning, and it becomes very powerful very quickly. German reviewers recommend the Arizer Solo 3 or Norddampf Relict for beginners and regard the Tinymight 2 as a device for experienced users.
Since February 2022, every device has carried a serial number and security code on the bottom plate. The original has a plus sign inside the battery cap; widespread counterfeits have a minus sign because the cell is fitted the opposite way round. Buy from retailers listed by the manufacturer or directly from the EU store.
Comments
No comments yet. Be the first!
Sign in to comment