Storz & Bickel Mighty: Troubleshooting & Error Messages
Pros
- Two lithium-ion batteries
- Passthrough charging supported
- Dosing capsules included
Cons
- Heating can take up to two minutes
- Heavier than newer alternatives
Troubleshooting & Error Messages for the Mighty. You can find the complete overview on the main page.
Troubleshooting & Error Messages
Short answer: For the original MIGHTY, STORZ & BICKEL documents four error codes: ERR 001 through ERR 004. ERR 001 and ERR 002 relate to battery temperature, ERR 003 to an unsuitable power supply, and ERR 004 to a device fault. If the MIGHTY won't switch on at all, the battery charge level should be checked first. Error codes from newer devices must not be applied to this model.
Error codes of the original MIGHTY
| Display | Meaning according to manufacturer | Safe action |
|---|---|---|
| No display / device does not start | The battery may be discharged. | Charge the battery fully and then switch on again. |
| ERR 001 | The battery temperature is too high. | Switch the device off and allow it to cool down. |
| ERR 002 | The battery temperature is too low. | Move the device to a warm location. Do not accelerate warming with a stove, microwave, lighter, or any other external heat source. |
| ERR 003 | The power supply being used is unsuitable. | Use the original STORZ & BICKEL power supply or the designated 12-volt car adapter. |
| ERR 004 | The MIGHTY is defective. | Unplug it from the power outlet immediately and contact the manufacturer's service. |
Safe diagnosis in the correct order
- Switch the device off and, with the power supply connected, unplug it from the power outlet first.
- Note the display and error number; for ERR 001 or ERR 002, allow the device to reach room temperature without applying external heat.
- For ERR 003, use only the accessories designated for the original MIGHTY.
- If the error persists or ERR 004 appears, do not open the device or attempt to repair it yourself.
- Have the serial number and proof of purchase ready and use the STORZ & BICKEL service.
Important model distinction
This table applies to the original MIGHTY and follows its official operating instructions. The manufacturer's current support page lists additional codes for MIGHTY+ and VENTY. Messages such as E05 or Bluetooth codes therefore do not belong in the fault diagnosis of the original MIGHTY.
When the device should not continue to be used
STORZ & BICKEL advises against attempting repairs yourself after any malfunction. If the housing is damaged, the battery behaves abnormally, ERR 004 recurs, or an error persists after cooling or warming to room temperature, the device should be switched off, disconnected from every energy source, and handed over to the service.
Manufacturer sources: STORZ & BICKEL: Operating instructions for the original MIGHTY, chapter Malfunctions · official download centre. Error codes verified on 26 August 2026.
For the USB-C model MIGHTY+, you'll find the differences for ERR 003 as well as SLO and dct on the page MIGHTY+: Error Codes and Charging Indicators.
Direct comparisons
Mighty Guides & Niches
Frequently asked questions
Depending on temperature and battery charge, heating takes up to 120 seconds. A vibration alarm and the LCD display show when the target temperature has been reached.
The Mighty+ has USB-C (instead of a proprietary 12V power supply), a ceramic-coated chamber, a shorter heat-up time (~60s instead of up to 120s), and stand feet. Both share the same hybrid heating system, the same temperature range, and Dosing Capsule compatibility.
Yes. The Storz & Bickel Dosing Capsules fit the Mighty, Mighty+, Crafty+, VENTY and Plenty. They are compatible across the entire S&B product family.
Disassemble the cooling unit. Soak its parts except the cap lock, and the filling chamber screen, in isopropyl alcohol for no more than 30 minutes. Allow them to dry thoroughly. Brush out the chamber after each session with the supplied brush.
Runtime depends on temperature and use. The Mighty has two lithium-ion batteries and can operate from its power adapter even when the batteries are empty.
No, the battery is built in. Storz & Bickel offers a battery replacement service.
The Mighty has been replaced by the Mighty+. Remaining stock is still available from some retailers. Accessories and spare parts are still offered by S&B.
2-year manufacturer's warranty. The original Mighty is excluded from the optional third warranty year.
The Mighty is cheaper. If you can do without USB-C charging and the ceramic-coated chamber, the original still offers excellent value for money.
Comments
No comments yet. Be the first!
Sign in to comment